IET
Decrease font size
Increase font size
Topic Title: Connecting a single phase motor
Topic Summary:
Created On: 30 June 2013 03:57 PM
Status: Read Only
Linear : Threading : Single : Branch
Search Topic Search Topic
Topic Tools Topic Tools
View similar topics View similar topics
View topic in raw text format. Print this topic.
 30 June 2013 03:57 PM
User is offline View Users Profile Print this message



mikek

Posts: 39
Joined: 13 September 2001

Helping a friend reuse a single phase motor. It has I think 4 wires going into it. They are connected (I think) to P, U and K on the attached photograph.



Clearly 240V across U & K - but I suspect there was a switch in the wires P-U.

But what do I know...

Any body here help me understand this please? Motor is rated 900W.

Thanks

M

-------------------------
mikek
 15 July 2013 07:59 AM
User is offline View Users Profile Print this message



oneye

Posts: 158
Joined: 25 February 2008

Why do believe it is 4 wire when the diagram shows 2 + earth ?
Do you know what the motor is intended to drive ?
Do you know what the switch Z1 is for - is it internal ?

Have you connected as shown ?
There could well be a switch between P and U connectors, to open once the motor had started.
 18 July 2013 08:45 PM
User is offline View Users Profile Print this message



philium

Posts: 6
Joined: 22 November 2006

I suspect the switch is internal overload / thermal protection
 03 October 2013 02:38 AM
User is offline View Users Profile Print this message



kengreen

Posts: 400
Joined: 15 April 2013

hi oneye,


This looks to me like a more fanciful version of the several capacitor Start/Run single phase motors which drive my several pumps. Basically these are a 2-phase motor in which the secondary winding is fed via a capacitor to produce the phase shift required to produce a spinning magnetic field. Monkey about with the connections and you can make such a motor run the "wrong" way.

A built-in thermally-operated switch is not uncommon; e.g. in my borehole pumps thermal protection is necessary in case the pump is powered when the borehole lacks water - in general water pumps are cooled by their own product.

Ken Green
 09 January 2014 05:15 PM
User is offline View Users Profile Print this message



christait

Posts: 24
Joined: 08 February 2013

www. flaktwoods.co.uk/c6816231-db65-47df-acf1-7afb53f8c4d4
Remove the space after www. and the above link shows various wiring configurations of this type of motor.
 20 March 2014 07:35 PM
User is offline View Users Profile Print this message



HarshalKhedkar

Posts: 3
Joined: 24 November 2013

I fully agree with reply made by kengreen.
I will add only one point that in addition to connecting single phase supply to terminals K and U, make sure that there is jumper between terminal P and U.

-------------------------
Electrical engineer with more than 20 years of experience in petrochemical plant project management, commissioning, maintenance and technical support.
Statistics

See Also:



FuseTalk Standard Edition v3.2 - © 1999-2014 FuseTalk Inc. All rights reserved.